DIY storage for Epoxy System

If you’ve ever considered using a car port floor epoxy system to safeguard and improve the look of your storage area floor, there are many things you need to know before purchasing one. Most diy stores hold epoxy floor kits designed for the do-it-yourselfer and you might have heard differing thoughts how well they work. Some will say it’s a fantastic product among others will let you know not to waste your money. Well, there exists usually a fairly easy explanation as to the reasons this product fails for some floors.
One reason behind failure is not every concrete floor is suitable for making use of an epoxy coating. Many floor surfaces have too much hydrostatic pressure, meaning water movements from the under the slab up to the surface in an activity called capillary action. Moisture then gathers on the surface, which breaks the relationship between the cement and the epoxy overcoat. If the ground “sweats” even though it’s dry exterior or there are areas that seem to stay moist for long periods of time, then an epoxy finish will almost certainly fail. It’ll slowly but surely chip and flake away. Even though you don’t think there is a moisture problem, it’s a good idea to use an efflorescence or sodium blocker prior to the epoxy. This will help prevent dampness from triggering problems.

The most probable reason for inability is poor surface preparation. The ground must be completely clean and stripped of most other coatings. Any staining or foreign substances (engine oil, grease, coloring, etc.) will prevent enough bonding between the concrete and epoxy, resulting in chipping and flaking. Most companies will apply a jacket of sealer to a garage floor after set up. It can take many years for the sealer to wear off completely. This sealer must be removed for epoxy to previous. Although acid solution etching can be an important step, you won’t remove sealer and most stains. Etching will only open up the skin pores of bare concrete, therefore you should do all cleaning and stripping before etching with acid.

Before purchasing a garage area floor epoxy system, you need to first decide if your floor is right for this. If it sweats often or there are areas that are constantly wet, then forget about it. Be sure that you are willing to take time to prep the ground properly, as this is actually the most critical part. It also really helps to put one or two coats of clear concrete sealer at the top to serve as a wear jacket. Water centered acrylic sealers are ideal for indoor domestic use. Despite any bad reviews you’ve found out about the do-it-yourself car port floor epoxy system, it’s rather a successful project if it’s done correctly.

Leave a Reply

Your email address will not be published. Required fields are marked *