Applying Epoxy flooring to Your Garage surface

Often we don’t think about our garages or pay much focus on the look of them. They are simply just a destination to park the vehicles and store the excess boxes of Holiday accessories and such. However, like any other room in your own home your storage floor must be taken care and attention of.
Due to the make use of it gets, coupled with normal water, gas and petrol that will inevitable be spilled upon it, garage floor coverings can simply become harmed and begin to fall apart after a few years of use.Epoxy layer is one means to fix your garage floors challenge. Epoxy covering applies a covering of sealant and protectant to your concrete garage floor to help it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floors requires a little up-front prep before beginning. The main step in the process is ensuring the ground you will apply the epoxy layer onto is free from moisture, residual car paint and does not have a cement sealer or other concluding put on it.
To check for moisture, take a sheet of clear plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and look for any moisture collecting on the side of the plastic material facing the ground. If moisture exists, than an epoxy floors coating is not ideal as epoxy requires a dry surface to properly bond with the floors.
Next, we’ll test to make sure the flooring doesn’t have a sealant already put on it. This test will also look for the occurrence of natural oils in the concrete as well. Take a cup of drinking water and put it immediately onto the existing flooring. It should soak in to the floor in an acceptable timeframe. If it beads or maybe sits together with the flooring then your floors has probably already been sealed or consists of oil contaminants. Epoxy floor is not suited to cement floors that have already been covered or contain any kind of essential oil residue as it will not bond.
Finally, if you are prepared to spend several months testing an area of your car port floor for suitability to installing epoxy flooring you can paint a tiny area with regular, oil-based enamel. If this test area endures for several a few months then it is likely an epoxy layer can last as well. However, if you opt to proceed with applying the epoxy finish you will need to remove this enamel finish that will require sanding.